The Viper 5304v is a two-way car alarm capable of sending and receiving commands to and from your vehicle via the LCD remote. This system incorporates all the features of the Viper 5104v and 5204v with a full screen of information in your hand.
5304v car security fitted from £799* (see notes below)
We are mobile Premium Clifford Fitters and will travel to your door providing expert installation for Winchester, Woking, Guildford, Worthing, to Bournemouth, West Sussex and Hampshire areas.
This system is similar to a pager remote car alarm with all alarm triggers being sent to the LCD screen. So long as the vehicle is within a distance, the screen on the remote control will show information about the alarm and vehicle status. The range on these devices is excellent, but customers should be aware that the ability to communicate is affected by obstacles such as buildings and electronic interference, and that we in the UK have many more obstacles than in the US.
As this system is all about the hand held remote, a function list is given in the table below. The Viper 5304v comes with one LCD remote and one basic one-way remote. Realistically the back-up remote will allow the alarm to function with the same security but will not give vehicle details, and customers should expect to source a new remote if the LCD one becomes lost or broken. The back-up remote also allows the system to be disabled to programme in a new remote.
This device is also SmartStart compatible should customers also opt to have this system installed at the same time.
Although the 5304v is an excellent security device it is not and insurance approved product. Thatcham does not recognise remote start systems and therefore this system is unlikely to gain insurance discounts.
The Viper 5304v is all about the LCD two-way remote. There are two main buttons on the front and three buttons on the side, allowing the function press to give levels one, two and three, by repeated presses. The current level is shown in the text field at the bottom of the LCD screen.
|Armed: System is Armed, alarm is enabled|
|Locked: System is Locked in Valet, alarm is disabled|
|Disarmed: System is Disarmed, alarm is disabled|
|Unlocked: System is Unlocked in Valet, alarm is disabled|
|Siren disabled for sensor triggers (sensor Silent Arm)|
|Siren is disabled for all triggers (full Silent Arm)|
|Remote Start is active, engine is running|
|Timer Remote Start is active|
|SmartStart is on|
|Manual transmission - the engine can be started|
|Vehicle interior temperature|
|On during Warn Away and full trigger output|
|Aux/Boot activation (if fitted)|
|Boot open therefore bypassed when arming|
|On during a sensor zone full trigger output|
|On indicates a sensor is active and bypassed when arming|
|On during door zone full trigger output|
|On indicates a door is open and bypassed when arming|
|On during bonnet zone full trigger output|
|On indicates the bonnet is open and bypassed when arming|
|You are transmitting to the vehicle|
|You are receiving from the vehicle|
|Out of range from vehicle|
|Pager on - remote is listening for messages|
|Pager off - remote will not wake up to listen for messages|
|Remote vibrates when messages received|
|Remote Beeps and Tones when messages received|
|Clock, Runtime, Temperature, Level indicator etc|
* Extra Parts and Labour will incur a reasonable additional charge as some vehicles require extra time for fitting e.g. Nissan Elgrand adds £80 to any alarm system, built motorhomes may need extra installation time, door motor fitting is charged extra on a per door basis, and transponder bypass modules will cost extra.
Viper 5304v fully fitted engine remote start car alarm Winchester, Woking, Guildford, Worthing, West Sussex and Hampshire areas.